Assembly – Connect Motor / Lower
- Align the pump motor with the lower pump end. Position the air inlet of the motor 90° from the material outlet.
- Install the two (90096) connectors and retain with the (90109) sleeve. Slide the (90102) retaining ring back into position.
- Reinstall the spacer rods to the pump motor and tighten mechanically tight.
NOTE: A 5/8" Box/Open End Wrench may be needed to assist in this process.
- Bring the motor and lower pump together and using a 15/16" Box/Open End Wrench retain with three (Y85-29-C) nuts. Gradually, alternately and evenly assemble three (Y85-29-C) nuts mechanically tight.
NOTE: A 5/8" Box/Open End Wrench on the (90531) spacer rod flats maybe needed to assist with this process.
NOTE: Be sure to refill the solvent cup with a compatible lubricant to protect the upper packings and ensure longest service life.
Assembly Complete.