Aro

Close

1. Introduction

2. Safety

3. ARO Aftermarket Parts Information

4. Disassembly – Overview Required Tools

5. Disassembly – Alignment Markings

6. Disassembly – Disconnect Motor / Lower

7. Disassembly – Remove Inlet Body

8. Disassembly – Disassemble Lower Body

9. Disassembly – Remove Ball Cap Assembly

10. Disassembly – Disassemble Ball Cap Assembly

11. Disassembly – Remove Solvent Cup

12. Disassembly – Disassemble Gland Nut

13. Disassembly – Remove Tie Rod Hardware

14. Disassembly – Remove Upper Body & Downtubes

15. Disassembly – Remove & Disassemble Tube

16. Disassembly – Remove Pump Rod Assembly

17. Disassembly – Disassemble Lower Packing Assembly

18. Kit Installation & Assembly

19. Kit Installation & Assembly Overview

20. Assembly – Lubricate Packings & Seals

21. Assembly – Assemble Lower Packing Assembly & Pump Rod

22. Assembly – Assemble Lower Packing Assembly Into Tube

23. Assembly – Assemble Downtubes

24. Assembly – Assemble Tube & Pump Rod

25. Assembly – Assemble Tie Rods to Upper Body

26. Assembly – Assemble Gland Nut

27. Assembly – Assemble Upper Packing Assembly

28. Assembly – Assemble Solvent Cup

29. Assembly – Assemble Upper Body

30. Assembly – Assemble Tie Rods

31. Assembly – Assemble Lower Body

32. Assembly – Assemble Inlet Body

33. Assembly – Install Ball Cap Components

34. Assembly – Connect Motor / Lower

Step 25 of 34

25

Assembly – Assemble Tie Rods to Upper Body

Apply Lubriplate Super FML-2 grease to threads on three (Item 12) nuts. Screw three (Item 12) nuts onto top end of (Item 10) tie rods and screw tie rods into (Item 11) upper body. With a ¾" box/open end wrench, tighten nuts snug to (Item 11) upper body.

Back

Next