Toggle navigation
2-Ball
2-Ball
4-Ball
Chop Check
Lower Pump End - Service Kit Installation (PN: 66475-XXX)
Lower Pump End - Service Kit Installation (PN: 66475-XXX)
Lower Pump End - Service Kit Installation (PN: 66475-XXX)
Lower Pump End - Service Kit Installation (PN: 66300-XXX)
All Steps
All Steps
Close
1. Introduction
2. Safety
3. ARO Aftermarket Parts Information
4. Disassembly - Overview Required Tools
5. Disassembly – Alignment Markings
6. Disassembly – Disconnect Motor / Lower
7. Disassembly – Loosen the Solvent Cup
8. Disassembly – Remove Nuts & Retaining Ring
9. Disassembly – Studs & Solvent Cup
10. Disassembly – Material Tube
11. Disassembly – Material Tube (continued)
12. Disassembly - Retaining Nut & Adapter
13. Disassembly – Remove Adapter from Plunger
14. Disassembly – Remove Adapter from Plunger
15. Disassembly – Remove Packing
16. Disassembly – Remove Ball Guide
17. Disassembly – Ball Area
18. Disassembly – Outlet Body
19. Disassembly – Outlet Body
20. Kit Installation & Assembly Overview
21. Kit Installation & Assembly Overview
22. Assembly – Lubricate Packings & Seals
23. Assembly – Outlet Body
24. Assembly – Install Plunger Parts
25. Assembly – Solvent Cup
26. Assembly – Adapter
27. Assembly – Adapter (continued)
28. Assembly – Adapter (continued)
29. Assembly – Adapter (continued)
30. Assembly – Tube on Outlet Body
31. Assembly – Foot Valve Body
32. Assembly – Foot Valve Body (continued)
33. Assembly – Foot Valve to Material Tube
34. Assembly – Foot Valve to Material Tube (continued)
35. Assembly – Foot Valve to Material Tube (continued)
36. Assembly – Foot Valve to Material Tube (continued)
37. Assembly – Connect Motor / Lower
Step 27 of 37
27
Assembly – Adapter (continued)
Place
(Item 31) pin
into the bottom pin hole on the bottom of the
(Item 26) plunger rod
.
Back
Next