Insert the new lubricated (Item 30) o-ring from the repair kit into the bottom of the (Item 33) adapter.

Make sure that the opening on top of the (Item 33) adapter is covered to hold the (Item 27) ball in place.

NOTE: Consider placing the top of the adapter in the palm of your hand.

In the bottom of the (Item 33) adapter, replace the (Item 27) ball and place the (Item 28) seat with the beveled edge side up, towards the (Item 27) ball.

NOTE: Apply PTFE tape to the threads per figure 1 on the operator’s manual.

With a ⅛" spanner wrench, tighten the (Item 48) retaining nut to secure the (Item 28) seat.

Tool needed for this step:

• ⅛" spanner wrench