1. Align the pump motor with the lower pump end. Position the air inlet of the motor 120° from the material outlet.
2. Install the two (94688) connectors and retain with the (94689) sleeve. Slide the (95069) “e” ring back into position.
3. Assemble the three (93866) spacer rods to the lower pump and using a 1 1/8” Box/Open End Wrench secure using three (Y14-750-K) lock washers and (Y6-128-C) cap screws. Gradually, alternately and evenly assemble three (Y6-128-C) cap screws mechanically tight.

NOTE: An additional 1” Box/Open End Wrench maybe needed to secure the three spacer rods while assembling the three (Y6-128-C) cap screws.

4. Reinstall the spacer rods to the pump motor.
5. Bring the motor and lower pump together and using a 1 1/8” Box/Open End Wrench retain with three (Y14-750-K) lock washers and (Y6-128-C) cap screws. Gradually, alternately and evenly assemble three (Y6-128-C) cap screws mechanically tight.

NOTE: Be sure to refill the solvent cup with a compatible lubricant to protect the upper packings and ensure longest service life.

Assembly Complete.